Skip to content

Juniper SRX Autorecovery Alarm Light

There are various reasons the Alarm light might come on. First to check, why you are seeing the alarm.

System Alarm Info

nish@iNET# <strong>run show system alarms</strong> 
1 alarms currently active
Alarm time               Class  Description
2013-11-02 01:09:17 GMT  Minor  Autorecovery information needs to be saved

In the above case, it is because Autorecovery information is not saved.

This is accomplished by doing the following command

Saving Autorecovery Info

nish@iNET> <strong>request system autorecovery state save</strong> 
Saving config recovery information
Saving license recovery information
Saving BSD label recovery information
comments powered by Disqus